Hygrometer stand

prusaprinters

I wanted to place one of my round hydrometers (D=45mm) inside my AMS to measure the humidity. It also works in general outside an AMS.Because of the space constrains inside the AMS this is a simple support that doesn't interfere with any parts. Instead of making it complicated, I opted to “mount” the hydrometer just with a tiny bit of double-sided tape. This should hold it secure until the battery needs to be replaced. The stand itself is just placed inside the AMS as shown in the picture without any fasteners, glue or tape.I printed it in PETG, my preferred filament, but PLA should be fine as well. Just locate the bottom flat onto the printbed, Supports are not needed.Designed in Fusion 360The stand prints in about 30 Minutes, using less than 10 grams of filament.