Hygrometer Sensor Holder for Sunlu Dryer

prusaprinters

<p>I modified this mount to fit the actual sensor better. The hole itself was perfect, but there was no room for the clips on the sides. I added a small indent on both sides to let the sensor slide in, now its nice and snug and you don't have to cut away any material to make it fit.&nbsp;</p><p>&nbsp;</p><p>Might see if I can integrate the “nut” into the mount itself.&nbsp;</p><p>&nbsp;</p><p>I've included the original nut and bolt which is recommended to be printed at 0.1mm layer height. I printed the holder at 0.2mm on its side without supports. The bolt hole definitely doesn't need supports, sensor hole may need supports if you printer doesn't bridge well.&nbsp;</p><p>&nbsp;</p><p>Printed in PLA</p><p>Holder @ 0.2mm (consider supports on sensor hole)</p><p>Nut/Bolt @ 0.1mm (recommended by original creator, haven't tested other layer heights.)</p>