HYDROPONIC STRAWBERRY TOWER

thingiverse

instructions for building a hydroponic tower for 9 plants the tools needed 40w soldering iron 3d pen plastic pipe for water 20 mm 3d printer drill and 4 or 5 mm drill 18 liter bucket 4 buckets of wipes a pump for a 10w aquarium that raises the water to a height of 1.20 meter. a4 adhesive paper for the printer plastic icons 2 tubes of plastic for sealing Assembly instructions take the 3 buckets and mark the location of the holes. Then carefully cut with a surgery knife. Then paste the triangles with a 3d pen once the triangles are connected use a soldering iron to strengthen .after then stick the sample to the lid of the large bucket and to the bottom of the small bucket to be centered. Grab with 3 zip tie thet will not move and drill the holes, then do the same with the small buckets .bottom of bucket with lid of bucket underneath .then connect the air pump to a 20 mm plastic pipe .then drill all the buckets in the center .or cut with a cutting knife that the pipe will pass through all the buckets.in the top bucket cut the tube in its top third and connect the .sprinkler then fill water in the large 18 liter bucket and connect all the buckets together. And check that system is working regularly.then seal the lids of the buckets with sealant to prevent leakage. Then let the system work 24 hours.replace the water and the system ready for operation