Hydroponic Bell Siphon

cults3d

This project is a bit of a work in progress but is part of a small 15" x 20" Ebb and Flow hydroponics system. To avoid having to cycle the pump I have designed this Bell Siphon to connect to a 3/4-Inch Double Threaded Bulkhead. This ensure a water tight connection between the container and the reservoir. To ensure that no material gets in the siphon I have also designed a cover that lets water in but blocks most material. My bell siphon has been designed to go in a standard Rubbermaid Bus/Utility Box that holds about 4.625 Gal. It Measures 5" x 20" x 15". The pipe has been fitted with a cap that helps get more water into the pipe and allows you to vary its hight by approximately 20mm. ** Pipe ** Material - Hatchbox PETG (red) Resolution - .12 Build Plate - brim / tape and glue from glue stick Infill - 25% Supports: Yes touching base ** Pipe Extender ** Material - Hatchbox PETG (red) Resolution - .12 Build Plate - brim / tape and glue from glue stick Infill - 25% Supports: Not needed ** Cover / Bell / Caps ** Material - PLA Resolution - .12 Build Plate - brim / tape and glue from glue stick Infill - 25% Supports: Not needed