HX115LR Insta360 Go2 Mount and Modified Case

thingiverse

updated M2 hardware version here: https://www.thingiverse.com/thing:5573966 Work in Progess - these files have not been tested! This mount was designed to slip onto the top plate of the BetaFPV HX115LR from the rear, and is held in place by the front two screws (you may need longer screws!). The part of the mount that is under the top plate is well aft of the FPV camera area and should not interfere regardless of your camera angle. It was specifically designed for the remixed Go2 case below, so I don't know what other case designs it will fit. It uses an M3 bolt to secure the camera, approx 18mm. HX115LR_LighterGo2MountV2.stl - This version of the mount has countersunk front screw holes, and is designed to fit with the Modified Go2 Case below. HX115LR_ModifiedGo2Case.stl - This is the G02 Case remixed from tokikawe. My goals were to make it easier to get the Go2 in and out of the case, and to lighten it up further. I don't yet know if either of these goals were achieved. Maybe someone with a printer can try it out and let me know! HX115LR_LighterGo2Mount.stl - This is an earlier version of the mount without the countersunk screw holes. HX115LR_BasicGo2Mount.stl - This is a basic version of the mount without the cutouts in the tabs. HX115LR_BasicCamPlatform.stl - This is the basic platform I created in Tinkercad to work from. It's based off of simple measurements on the HX115LR top plate, and may not be perfect yet. I will update once it has been printed.