HX115LR Go2 Mount and Case V4

thingiverse

Work in Progess! General explanation: This mount was designed to slip onto the top plate of the BetaFPV HX115LR from the rear, and is held in place by the front two screws (you may need longer screws!). The part of the mount that is under the top plate is well aft of the FPV camera area and should not interfere regardless of your camera angle. It was specifically designed for the remixed Go2 case below, so I don't know what other case designs it will fit. It uses an (approx 15mm long) M2 bolt to secure the camera. -------------------- V4 Revision notes: HX115LR_Go2MountV4.stl - The only change was lessening the depth of the countersink on the two mount screw holes. The V3 version was a little thin in that area with the potential for the screw heads to break through. At this point I would consider good to go! HX115_Go2CaseV4.stl - 2 small changes here: 1. Slightly modified the shape and depth of the filter protection because I was still getting a little bit of that in the camera view at times. 2. Added one more little cutout on the back to try to make it easier still to get the camera in and out of the mount (for filter changes). These mods are yet to be printed and tested. -------------------- V3 revision notes: I'm quite happy with this new version (V3). Overall it saves roughly 4 grams over the V2 version, partially from switching to M2 hardware, and partially from redesigning the case and mount. The Go2 is also now easier to get in and out of the case. The tiny holes for mounting to the frame still needed to be burnt open a little with the fine tip soldering iron. The holes in the tabs on both the case and the mount could stand to be widened up in the next version so the bolt slides through freely (done but yet untested in V31), but this version is totally manageable. -------------------- HX115LR_Go2MountV3_M2.stl - This is a slimmed and tidied-up version of HX115LR_LighterGo2MountV2. It now uses M2 hardware instead of M3, and includes provision for a recessed M2 nut allowing for a shorter bolt. It is designed to fit with the HX115_Go2CaseV3 below. HX115_Go2CaseV3.stl - This is updated from HX115LR_ModifiedGo2Case.stl, remixed from tokikawe. This version is lightened further, and uses M2 hardware to match the mount above. Also, I shaved a sliver off the front of the filter protector because my first print was barely visible in my camera.