Humane Mouse Trap Using 2L Pop bottle

thingiverse

- Requires file from source design for main body. - Found it fit a 2L pop bottle. - The original uses a ball as the stopper. My remix adds a cone on top of the ball. This part can be printed cone down in one piece without supports. The cone is only slightly tapered so it maintains orientation in trap (cone up). - SCAD file included. Note that to use the scad file the OpenSCAD app is required as it modifies the original STL. - I modified the cap/lid to make it harder to chew through. - SCAD file included. Note that to use the scad file the OpenSCAD app is required as it modifies the original STL. - I had some aluminum foil tape handy so I used a small amount inside and outside on the cap to discourage chewing. Also put some on flat part of stopper. Better photos will follow. Will update if I catch anything.