Human Brain

thingiverse

This two-part Human Brain model by jmil is printable without assistance and looks impressive when disassembled. It was challenging to create, so good luck! Ideal for Ultimaker owners, it's printed using Faberdashery Pink PLA. To print successfully, use at least 8% infill; a higher percentage will require more plastic and time. Print with a standard 0.5mm nozzle and 0.3mm layer slice. Expect large Gcode files (30MB+) per part, so printing from an SD card is recommended. Each half took approximately 8 hours to print on a Prusa i3 with heated bed. A small fan helps cooling without affecting the hot-end or bed temperature, especially for its numerous overhangs and thin sections.