Hultarp Magnetic Rack Mount for Skadis

thingiverse

Mount IKEA's magnetic Hultarp knife rack to the Skadis pegboard. No extra hardware needed, just a flat head screwdriver to twist in the pins. Print one of each pin. The orientation of each corresponds to the holes in the Hultarp's bracket. The mid-support is optional but recommended. It keeps the bracket in place and also takes some of the weight off the pins, especially when held to the bracket with double-sided adhesive tape. For best results: + Use a layer height of 0.12mm or lower on all pieces. + Print the pins with 100% concentric infill or increase the number of perimeters/walls. The mid-support can be printed with minimal infill. + Use supports on all pieces. Ensure all support material is fully removed and cleaned up. + Apply forward pressure when twisting the pins in place to avoid snapping. + Use a filament with a bit off flex, like PETG. PLA works fine but can snap. Note: The holes in the Hultarp bracket line up perfectly with the Skadis, so you could also attach it with some M4 bolts and washers. The mid-support would still be useful in this case.