Hue Dimmer V2 Cover for Gira 010600

thingiverse

I designed this cover to fit over the existing light switch in my flat. Hope someone else finds it useful. It has pins located at the back that have to be inserted into the slots of the Gira 010600 and then rotated about 20°. Afterwards you can secure the cover with the 3d printed screws. The first part of the installation can be a bit finicky and you have to be careful to not damage your wall while rotating the cover, if you have woodchip wallpaper like I do. When you install the plate, that holds the dimmer to the cover, you do not have to use the screws, the glue strips should be strong enough. In case you use screws like I did, do not tighten them too much as the corners of the plate with flare out and create a gap to the cover.