Hudson Keyring

thingiverse

Human: I customized this version of the original project at Thingiverse. It was made with their customizer tool found here: http://www.thingiverse.com/apps/customizer/run?thing_id=834725 Customization options were used to make changes: The height setting ranges from 10 to 8 units high, 7.5 units, 8.8, and so on. The selected height for this customized project is a single value of 10 units. Text was changed with a simple replacement of the original name with the word Hudson. Line spacing options range from 12 to 13 points. In this customized version, we used two settings of 13 and another two at 12.5. The position where you would start printing loops is fixed at exactly 10 units for all prints on this job. Two different settings were selected for twisting - a value that controls the angle of print layers in mid-print - set to minus 10 degrees in total and changed with one extra adjustment setting plus a bit more in another. It is an even higher setting in another, slightly above its default position but then changed lower down as we reached near to halfway. In order for our custom design to center itself in the printer, the X position has been moved away from any edge at just exactly 20 units from there. This design used Chewy fonts exclusively throughout which is known by some people for having a fun twist while being easily readable due especially to those letter forms they come up in quite nicely shaped and big enough so all will do their best no matter where they find it. The final adjustment you see is that our rotation settings reached almost exactly halfway around then changed - going a little further round once we hit middle but did the job without any need to move right down towards edges before reaching outwards even further just for some finishing touches done really quite nice overall too looking really smooth actually which will always get people’s approval without a doubt no question asked ever evermore