HUBSAN ZINO - Under-belly GoPro support

thingiverse

I designed and revised this support many times to get the correct balance between toughness of the coupling and possibility of releasing the structure from the Zino. It's a very delicate balance, anyway. The best solution I found was to put two longer levers under the clip system. They're used to facilitate the opening of the "clamp" to assemble and disassemble the support without damaging the external sides of the Zino. I don't even exclude I will possibly stretch them to have an even greater leverage effect. I also struggled against all that radiuses and inclined faces that Zino presents. That's why my support has very few rectilinear or parallel sides... Holes are mainly to lighten structure where reasonably possible. The STL file is already oriented in the way I believe it should be printed to get the correct rigidity of the structure. Of course, finding better ways, is up to you :-) In order to improve the safety of the hook system, I applied an additional flat part, opposite to the clamp, in order to accommodate a Velcro strip or a rubber band: feel free to use it or not, on the base of your opinion. To tell you all the truth, there's an accommodation for a Velcro strip also on the clamp ;-) Please feel free to print, to try and let me know about any improvement you think it may need. If you print it, please publish your "Post a make"; I'll be glad to see that my work is somehow useful. Of course if you need a support and you don't have the printer, contact me freely :-) I will be happy to see that my work is useful.