Huawei CP60 Qi wireless charger stand for iPhone Xs Max

thingiverse

Human: Designed for Huawei Qi wireless charger CP60, remade specifically for iPhone Xs Max with phone case in mind. Also works for phones of similar sizes without needing a resized model. Tested on iPhone X, XS, XR and all worked flawlessly. 05.30.2019 UPDATE Uploaded rotated version; just adjust the Z position to -0.2mm (or more) to ensure a complete first layer. WARNING Printing with the bottom side facing down towards the print bed is not recommended as the support will be difficult to remove, and structural strength won't be optimal. I learned this lesson the hard way. Printing with the back side surface facing down towards the print bed is highly advised; just rotate it manually to make the surface parallel to the print bed, then set the Z position value in minus a little bit to ensure a 100% flat surface. This method saves time and filament while making support removal much easier (I use Cura tree support). Either side facing down towards the print bed will provide the best structural strength; however, I haven't tried this personally. Welcome to be the first one.