HUANUO Monitor Mount Cap

thingiverse

Replacement piece for HUANUO monitor mount cap. Underside peg doesn't extend past part so it spins around freely. Could use some remix or adjustment to make sure it will stay in place. Use supports. I used Cura tree supports with angle of 60 to reduce usage. Estimated at 17g of material and it ignored supports at the incline. If you do it this way, I'd suggest wall ordering of Inside to Outside. I did Outside to Inside and there were floating perimeters on the underside I had to clean up. Still usable; just let it finish. Taper angle around part is 2mm, but that seems shallower than original part so it could be adjusted.