HTD 3M 50Tooth Parametric pulley - lots of tooth profiles

thingiverse

Human: Customized version of www.thingiverse.com/thing/16627 Created with Customizer! www.thingiverse.com/apps/customizer/run?thing_id=16627 Instructions Using the following settings: idler_ht is set to 1.5 idler is disabled by default m3_nut_flats is set to 5.7 m3_nut_hex is enabled with 1 number of flats additional_tooth_width is increased to 0.2 additional_tooth_depth is disabled by default no_of_nuts is set to 2 in total retainer_ht is elevated to 2 units high profile is adjusted to setting number 9 teeth are spaced out evenly with a count of 50 pulley_b_dia is reduced to a diameter of 40 nut_shaft_distance is decreased by 1.2 units pulley_b_ht is set at 8 units tall pulley_t_ht is adjusted to reach a height of 10 m3_dia is narrowed down to a diameter of 3.2 retainer is activated with option number 1 nut_angle is locked into place at a sharp angle of 90 degrees m3_nut_depth is increased by an extra depth of 2.7 units motor_shaft is connected using the existing shaft length of 3.2