HTC ONE Raptik 2.0

thingiverse

In this revised Raptik phone case design, I reduced plastic usage and size while maintaining durability. Two slides have replaced the latches for ports, and plastic toggles now replace challenging-to-press rubber bumpers. This allows you to print the entire case without flexible filament if desired. However, it is recommended to use soft filament for the left and right bumpers. The tolerances are tight; printing at 1-2% larger than actual size is advised due to plastic shrinkage. You will need eight 10mm or, for a flush fit, ground-down 15mm screws. Duel extrusion files are also included in the package. This version is still experimental and open to improvements; feedback is appreciated.