HSKRC Freestyle 250 Ummagawd Remix Gopro 3 holder

thingiverse

Mount the HSKRC Freestyle 250 with a tilt of twenty degrees to fit your GoPro 3 series perfectly. Check out this YouTube video to see how well it works: https://www.youtube.com/watch?v=MYIt4LbvZA0. Print this holder using TPU or Ninjaflex material, and set the extrusion speed to thirty percent with two perimeter walls. Make sure all fans are running at full power throughout the print process. Don't worry about air flow; it won't be a problem. If you need more information on the FFF profile, head over to our download section for further details. I use a CTC Bizer MK10 printer and have these TPU print settings set up: General Settings: Retraction Distance: 1.5mm Retraction Speed: 25mm/s Nozzle Diameter: 0.4mm Layer Height: 0.15mm Solid Top/Bottom Layer: Five Perimeter: Two Infill Pattern: Full Honeycomb External Fill Pattern: Rectilinear Overlap: Eleven percent Minimum Infill Length: 0.1mm Support Settings: Support Infill: Seventeen percent Extra Inflation Distance: 1.6mm Dense Support Layer: Three Dense Infill Percentage: Sixty-five percent Horizontal Offset: 0.2mm Temperature Settings: Table Material: ABS Juice (be careful not to touch the thin film!) Extruder Temperature: Two hundred and thirty degrees Celsius Table Temperature: Zero degrees Celsius (or twenty-five degrees) Fan Settings: All fans run at full power always, even during the first layer. Speed Settings: General Speed: Thirty-seven millimeters per second Outline Speed: Sixty percent of general speed Infill Speed: One hundred percent of general speed Support Speed: Eighty percent of general speed X/Y Axis Move Speed: One hundred and fifty millimeters per second Z-Axis Move Speed: Twenty-two point five millimeters per second Other Settings: Extra Inflation Distance: Five square millimeters Bridging Speed/Extrusion: One hundred percent Allow Single Extrusion for Internal and External Infill Allowed Perimeter Overlap: Fifty percent Minimum Travel for Retraction: One point zero millimeters