HS1177 Mount for BeeRotor X200

pinshape

Mounting the HS1177 camera to the BeeRotor plate was a frustrating experience. It required hot glue, but after a day of intense racing, the camera would detach from the plate. I aimed to design a solution to this problem. I only use the higher tilt angle, so I don't test on lower angles. Update: The v2 file works well, but with my VTX in place, the HS1177 was too far back, making it all a bit cramped. On the v3, I moved the side flanges back slightly to push the camera body forward and added a chamfer to the side section. These changes move the camera forward enough to clear my VTX and provide some extra room for modifications. Print Settings: Printer: Wanhao Duplicator i3 Rafts: No Supports: Yes Resolution: 0.15 Infill: 100 I print at 100% infill because it doesn't significantly impact the printing time for me. However, the overhang on the 'nubs' will likely need support unless your printer can handle a 2mm 90-degree overhang flawlessly, in which case the part won't fit into the frame slots.