HP Z840 2.5 INCH TRAY

thingiverse

Design draws inspiration from McThon's SSD Tray for HP Z840 at https://www.thingiverse.com/thing:1104634. However, I encountered difficulties printing his design due to the relatively small build plate of my Flashforge Finder (140mm x 140mm). The model would warp significantly on the non-reinforced side even after leveling the build plate. To address this issue, I modified all corners and adopted a rounded appearance in Spatula mode because rounded corners tend to exhibit less warping during cooling. The caddy holes are a precise fit for the Z840's tray, and screws can be added to the rails on the right side to secure the SSD. These screws were made adjustable due to my inability to accurately measure the distance between the end of the tray and the connector for a snug fit. Dimensions: 129 (L) x 101.16 (W) x 15 (H)