HP STORAGEWORK MSL2024 TAPE LIBRARY DRIVE SPARE PART

thingiverse

AS ALREADY MENTIONED IN THE TITLE, THIS IS A REPLACEMENT PART FOR THE **STORAGEWORK MSL2024 TAPE LIBRARY**. THE GUIDE ON WHICH THE DRIVE GOES UP AND DOWN WAS SKETCHED AND 3D PRINTED. IMPORTANT: IT IS NOT NECESSARY TO REPLACE BOTH SIDES! THE PARTS HERE HAVE BEEN REPRODUCED ALMOST 1:1 AND **WILL WORK EVEN IF ONLY ONE OF THE TWO IS REPLACED!** I recommend using nylon as your filament because of the gear guide. Alternatively, you can also use PLA. I can't recommend ABS etc. because they are more brittle and not as flexible, which means that the gears can break more quickly. The Nozzel should have a size of 0.2mm! **Make sure that you insert the drive straight into the guide**, if the drive is at an angle in the guide or if it is higher in one side than the other, you have inserted it incorrectly.