HoverGames NavQ case

thingiverse

Update - 12/16/2020 -=-=- Increased the top holes in NavQ Lower Case V22 to 4.5mm with 8mm Annular ring to allow for screw head clearance. This was requested to allow long screws to be used to hold the board in place and directly screw to the carbon fiber mounting plate. The original Lower case file is kept as-is, use V22 if you want this option. -=-=- This is a shell case to protect the www.hovergames.com NavQ companion computer. The top should allow the Coral camera mount to screw in and provide clearance on the backside for the screw heads. Note that the camera mount is optional as there are also locations on the top drone plate where the camera can mount also. The top will snap into the bottom. There are small relief areas for the Ethernet LEDs and the WiFi/BT antenna cable to pass through. I'll upload the source files as well. This print is somewhat fine, so you may need to ensure your printer is working really well. Alternatively you could use an FDM printer. open to any suggestions for improvement!