Hover Rider Captain (28mm)

cults3d

Hi all, A model I designed from scratch based on a TTS mesh: - included most of the details - completely reworked the engine/tubes design - created an entirely new pilot based on a "prime soldier," and equipped him with captain-level attributes - used my bikers model's melta gun This model should be fairly easy to print, requiring minimal supports. Use 1.75 filament bits for assembly pins. Some essential Cura settings: - union overlapping volumes - supports: zigzag (15% density minimum) + support roof, allowing a Z support spacing of one layer - recommended layer height is 0.1mm or less Let me know if you're interested in custom variants! Please consider sending a tip if you enjoy my printable models. Note: These models are created from scratch using freehand design in 3D modeling software and do not infringe on any copyrighted products. They are intended for personal use as proxies and should never be sold. If copyright issues arise, I'll remove the model.