Housing for RAMBo mini 1.3A

thingiverse

I recently purchased my original Prusa i3 printer. I really enjoy using the printer but have a few complaints: the housing for the RAMBo mini 1.3A card is rather flimsy. Additionally, I'd like to see the RAMBo from the side of the printer so I rotated it by 180 degrees with the parts printing outward. The way the cables enter the original housing appears strange to me. I rearranged them and created new holes for cables and cable covers in and through. My case requires twenty screws, including four additional ones for the Rambo, so you will need twelve extra screws, similar to those used in the original housing, which are M3 x 10 screws. [Updated October 31, 2015] I have moved the holes for screws to make it easier to open the housing. [Updated November 2, 2015] I fixed three minor errors on the bottom, back, and left plates. The back plate lacked a screw hole for connecting the bottom plate. There was an excess of 1 mm where the bottom plate did not fit well against the back plate. A 1 mm gap existed between the bottom plate and the left plate. [Update November 10, 2015] I removed the 'This Thing is a Work-In-Progress' status because the case functions properly for me with my original Prusa i3. Print Settings Rafts: No Supports: Yes Resolution: .2 layer height Infill: 50 Notes: I printed using ABS at 255 degrees nozzle and 110 degrees heat bed. Some parts must be rotated before printing because of shrinkage, so I had to print at 101% for the correct sizes.