Housing for Pollin LCD screen with touch LS-7T

thingiverse

Print all parts. For the inner parts a layer height of 0.25mm is sufficient, the outer parts can be printed with a smaller layer height like 0.2mm-0.15mm for a better look. You should print 2-3 shells and 3-4 roof and bottom layers. Infill 20-30%. All parts can be printed without support if oriented correctly. Assembly: 1.) Screw the large controller board to 'LCD_Controller_Halterung' with M3 countersunk head screws (M3x6 or M3x8). 2.) Screw the touch controller to 'LCD_Controller_Halterung' with M3 countersunk head screws (M3x6 or M3x8). (Pic1 and Pic2) 3.) Screw the keyboard to 'Tastatur_Halterung' with one (!) short M2 countersunk head screw or one short M2 cylinder head bolt (M2x8). (Pic3) 4.) Screw the keyboard to the controller assembly with one (!) long M2 countersunk head screw or one long M2 cylinder head bolt (M2x12). (Pic4, Pic5) 5.) Insert LCD panel into assembly and connect the flex cable to the controller. (Pic6, Pic7) 6.) Connect flex cable of touch screen. 7.) Remove protective foil from LCD. 8.) Insert everything into front bezel ('Frontrahmen'). (Pic8) 9.) Attach back ('Rueckseite') (sort cables, insert twin cable for power and FBAS right way around, insert USB cable into larger notch) and screw with 13 pcs M2.5 cylinder head bolts (M2.5x10). (Pic9, Pic10)