Housing for LCR-T4 with folding stand

thingiverse

To assemble the device, you'll need: - A separate micro USB plate - A 3mm screw with a 70mm shaft - Any available screws will do The most important thing is to attach the matrix and lighting to the body Attached are SolidWorks files for editing Probes can test both regular components and SMDs To make probes, you'll need: Take three plates, apply oil to the device's connector Insert the three plates with soldered wires into the device (Wires must be thin, I used 1mm diameter wire) Lower the lever and seal it inside and outside with glue (cold welding) Solder (with a hook clamp) to the ends, then sharpen them I used special 3D printing material