Hotwheels Track Connectors and Accessories

thingiverse

Work in progress! My kid loves Hotwheels, but also likes driving the cars on the wall, so I figured I'd start and accessory collection and have fun with it! There's lots of other good stuff on Thingiverse for Hotwheels but I'll still be growing this collection for things I can't find. Specifically I'll be adding wall mounts that work with 3M command strips so you don't have a million holes everywhere. Refer to the PDF dimensional drawing if you'd like to make your own connectors and accessories. Happy printing! :) Parts Description: 1) Basic Connector - Puts two pieces of track together 2) Basic Connector w/ 2.5mm hole - Puts two pieces of track together and has a 2.5mm hole in the center of the button to allow you to mount it directly to a surface with a small nail or screw. 3) Basic Connector w/ 5mm hole - same as #2 but for bigger screws 4) Wall Mount A (with barrel tube and cap) - single-screw mount system where you mount the barrel tube to the wall with a screw, then slide the wall mount over it and secure it with the threaded cap. The wall mount ring has a snug fit around the barrel but allows the mount to rotate with the curvature of the track. 5) Wall Mount B - Similar to mount A, but without the barrel shenanigans. Just screw it to the wall (mount hole is 5mm diam). 6) Wall Mount C (Single and Double) - Mounts the track perpendicular to the wall. Used for start/end points. Recommend taping a piece of sponge to the wall if it's at the end! 8) Stacked Single Lane Connector - It's a bridge where the tracks are running on top of each other in the same direction. *** will be adding perpendicular version soon! 9) Starting ramp for table - Has tabs on the foot of it so you can either clamp or tape it to a table. My kid likes to yeet his cars off tables, so I have a few of these and he's all about it. 10) 2 and 3-Lane Aligners - Smaller tabs that go anywhere in the track just to keep lanes together. 11) 2-lane Connectors - 2-lane versions of #1, #2, and #3