Hotend wire Guide for Anycubic Mega S

Hotend wire Guide for Anycubic Mega S

thingiverse

The idea published by Scigola (https://www.printables.com/model/151610-anycubic-i3-mega-sostegno-cablaggio-estrusore) is pretty good! However, the Anycubic i3 Mega S is shipped with a 12mm Diameter wire sleeve. This and the bowden tube often get tangled up in the Z-portal. That's why I adopted the fundamental idea and designed it for the larger sleeve diameter and angled it back to give the wire harness and the bowden tube a push to the rear. Much better than plates at the frame which usually don't work well either. As there is close to no space it took me a few attempts to find a solution which works. Nice side effect: as longer I tinkered around as simpler it turned out, fast to print and with a print orientation which makes it less prone to breakage. No idea whether the original allows full print height but I seriously doubt it. All I used from the original design was the bracket which I butchered a bit. Print parameters: 0.15mm layer height and adaptive layers Infill 30% cubic with double line Support everywhere Material PETG (or ABS/ASA but PLA might be sufficient too). As I print PETG pretty slow print time was ~20 minutes. The bracket is attached in the 2 holes with a new the tie wrap (cable tie) but two M3 screws and nuts could be used too. To hold the harness in place a small tie wrap is used thru the hole to hold the sleeve.

Download Model from thingiverse

With this file you will be able to print Hotend wire Guide for Anycubic Mega S with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on Hotend wire Guide for Anycubic Mega S.