hotend support, with Z probe for cr-10 smart

thingiverse

Replaced the strain gauge with the light sensor found down on the left column of the printer, and wired it to an skr mini E3 v3.0 I printed it on it's face, with some supports (if i remember correctly) out of petg. The stick needs some metal glued on it's side to properly and accurately interrupt the signal of the sensor. Wrapping alluminum might work, but until a friend told me this, i already cut a little rectangle from a beer cap lying around my room. The screws are all original, i mean from the printer somewere Finally I start trusting this printer now.