Hotend Exhaust Cover

thingiverse

I was getting large corner curls on a print no matter what I did with the printer. I reset my Sonic Pad, re-set up everything from scratch. I replaced the entire bed, changed the hot end, purchased a new glass plate, nothing helped with the issue. I looked into where the hotend fan exhausts, and it is off the right side of the print head. There was just enough air movement from the exhaust that caused the curling so I made this part to attach to where that exhaust is, and direct it upwards.One file will have an extended piece with pilot holes for attaching the Vibration Sensor that comes with the Sonic Pad.