HOTA D6+ Stand

prusaprinters

I designed this charger stand with a 5 degree angle to reduce glare on my HOTA D6+ hobby charger which was hard to see on my bench and pit table. It also raises the charger up providing additional airflow to underside of charger. The framework is minimal and assembles with snap-fit features. There are also grooves to use O-rings for extra retention at the corners if desired.Print InstructionsPrinted in PETG at 0.3mm layer, 10% infill. Print the following part qtys:1X HOTA Front1X HOTA Rear2X HOTA Side