Hornady Lock-N-Load Bullet Tray

thingiverse

This is a remix cmil1207 bullet tray for the Hornady LNL AP press. I redesigned the dovetails to make it easier to take the tray off and put on the press. I added another dovetail slot on the bullet tray so you can position the tray in two different positions. I also redesigned the way the clip attaches to the press. I tested this with about 100 200 grain 45acp bullets on the tray and it held fine. My reloading press has the older square style support beam, so I wasn't able to test the new style clip, but using the dimensions from cmil1207 clip I modified it like my design. Edits: 12/28/20 Uploaded wrong clip for new style press. Files now updated to correct one. 12/29/20 Made a few minor changes to the new style clip. 1/8/21 Added 2 revised clip designs. I made the dovetail a little bit wider so it locks into the tray a little better. I'm going to leave the originals up though incase those work better for some people. 1/9/21 Added a full box version of the bullet tray. 1/23/21 Added all new clip designs that use screws to hold the clip on the press. The dovetail part will fit both clip designs depending on if you have a new or old press. It's designed to use #8 5/8" screws.https://www.mcmaster.com/90077A196/ Also added another bullet tray deleting one of the dovetails to give clearance to some that may be using the inline fabrication handle. 2/2/21 Added 2 new tray designs a medium and large size. I'll be working on a version of the universal dovetail that drops the tray down a little lower to work better with the new tray designs. 2/13/21 Added Ex Large bullet tray and added a drop down dovetail for the screw type clamps. Also added 2 new clamp designs to accommodate some newer presses with the ridge that runs along the back. This relief cut might also allow room to install the light kits for these presses. 5/21/21 Added a wider and widest clamp version for the new style presses. Hornady apparently has a few different versions of the castings for the new presses. This clamps should fit those presses better. 7/2/21 Added a version of the bullet tray that should fit presses with roller handles like the Inline Fabrication handles.