Horizontal Phone Holder/Charger

thingiverse

Update: Due to your request, I've attached the Fusion 360 file for this item. It's a derivative of the previous design and while it doesn't have the most attractive appearance, it prints well. Please check out my alternative charger designs for a different approach: https://www.thingiverse.com/thing:3455211 Update: I noticed that the power cord openings weren't following the 45-degree rule, so I modified them to avoid supports. I liked the original version of this holder because it featured all 45-degree angles and printed well without supports. Since my daughter uses her phone for recipes in the kitchen, a horizontal charging position was more convenient, and I modified the original design to accommodate that. It works nicely with the S6 and S7, and I'm sure many other phones will fit as well. The charger is a cheap Qi from Banggood but works quite well. If you're particular, you'll want to add supports at the plug opening on top of each side as well as the top of the arc, but it seems to print in ABS without too much trouble without them. Print Settings: Printer: Flashforge Creator Pro Rafts: No Supports: No Resolution: .2mm Infill: 15% Notes: Nothing fancy. Sliced with Simplify3D