Hooks for pegboard(8mm hole, 30mm spacing)

thingiverse

Two hooks for perforated hardboards. These parts are specifically designed to fit 30mm spacing and 8mm hole boards only. If you attempt to use them with pegboards made on inch, it simply won't work. To achieve optimal results, we highly recommend laying down in the recommended position during printing. Print Settings are crucial to producing a high-quality print. Print Settings are where you fine-tune your print job's specifications. We break this section down into three essential areas: Rafts, Supports, and Infill. Rafts provide stability to your model during the initial stages of printing by laying a thin foundation underneath it. Don't worry about this setting unless you're working with models that need extra support at their base. Otherwise, you can set it to 'Doesn't Matter.' Next, we have Supports which add reinforcement and stability to overhanging parts of your design. This setting allows you to determine how extensive these reinforcements will be in the model's printing process. Once again, if not necessary, simply opt for 'Doesn't Matter.' Finally, we get to Infill – this refers to how dense the model is printed within its inner structure. With a 50% or more infill rate, you ensure your print job maintains its integrity and can support loads evenly without creaking apart.