Hook / Haken

thingiverse

Hook / Haken A simple hook is shown here. / A simple hook, as seen below. Total length / Total Length: 137.5 mm Diameter hook / Hook Diameter: 40 mm Diameter eyelet / Eyelet Diameter: 15 mm The hook is split in half and can be assembled with two pins and glued together. The hook consists of two halves that can be put together using two pins and then bonded. / Printparameter / Print Parameters Printer / Printer: Velleman K8200 Material: PLA Temp. Extruder: 190 °C Temp. Bed / Bed Temperature: 50 °C Layer height / Layer Height: 0.25 mm Perimeters / Perimeter Layers: 4 Solid Top Bottom Layer / Solid Top and Bottom Layers: 4 Infill / Infill Density: 40 % *** Update 14.01.2018 *** I performed a second stress test, using all my weights together which total 73.5 kg. No visible damage to the hook was found after this test. Another test will be conducted, aiming for a weight of 100 kg. However, I will need another location for that. Attention!!! The use of the hook as a lifting tool is at your own risk! / I conducted a second stress test on January 14, 2018. All my weights combined amount to 73.5 kg. Despite this, no damage can be seen on the hook. Another test will take place, which should reach up to 100 kg. But I definitely need another place for that. Attention!!! The use of the hook as a lifting tool is at your own risk! *** Update 26.12.2017 *** I conducted a stress test and found that the hook lifted 50 kg without any visible damage. Further testing will take place soon. Attention!!! The use of the hook as a lifting tool is at your own risk! / There is also a one-piece version of the hook available, which requires a support structure for printing.