Hook for Raspberry Pi Mount for Prusa i3 MK3/MK3S

thingiverse

I had been using the MK3 OctoPi Case by hackoholic (https://www.thingiverse.com/thing:2334119), but was annoyed how much work was required to remove the Raspberry Pi whenever I wanted to work on it, but I liked how and where it was mounted. I also didn't really care about having a fully enclosed case for the Pi, as it's not really in a place where it's in danger, so I found splitbrain's "Simple Raspberry Pi Mount (press-fit)" case (https://www.thingiverse.com/thing:3202131) and his "Hook for Raspberry Pi Mount" (https://www.thingiverse.com/thing:3180448) ...so I combined the hook with the mount from hackoholic. So yeah, print this thing, and then print splitbrain's "Simple Raspberry Pi Mount (press-fit)" case (https://www.thingiverse.com/thing:3202131), screw it into the MK3 or MK3S frame above the Einsy enclosure with 2 M3x8 screws and you're good to go! Thanks to hackoholic and splitbrain for the original designs! (Note that you should use supports on the build plate to print this).