Honeywell DCP-311 DCP-511 Doorbell Mount

thingiverse

This is a mounting plate for the Honeywell DCP-311 / DCP-511 doorbell push button. You will need to print this with supports (everywhere, not just touching the bed), and the support needs to be removed carefully to make this a good fit. If you print this flat on the bed (as I did) that will obviously be the weakest orientation for the "hooks". However, it did work in that orientation for me: I just used a slightly higher print temperature, slightly slower print speed and 4 perimeters and was able to print successfully in PLA, and the hooks have been holding up well so far. Theoretically this might be stronger if printed on its side, but I haven't tried that myself. If the button is a tight fit, do not force it. Remove it and gently clean away any remaining support material with a small file before trying the button again.