Honeycomb homes for LPS

prusaprinters

<p>Have you ever had these little monsters (Littlest Pet Shop) everywhere on the kid's room floor? Was it impossible to walk anywhere even if you cleaned them up somewhere in a box every day... again and again? Then you might want to install these little houses and maybe you will be surprised as we were at our home :-D</p> <h3>Print instructions</h3><p>Nozzle: 0.4<br/> Layer height: 0.3<br/> Perimeters: 2<br/> Top/bottom layers: 2/2<br/> Infill: 10%<br/> Supports: No<br/> Material: PLA</p> <p>TIP: Install them on a wall using both-sided tape (small pieces) - just test which tape works best for your wall to not screw it up too much when removing it in future or choose a place where you don't care :-D</p>