Honeycomb Bravo Flap Lower Cover

thingiverse

I disliked that the bottom of the Bravo flap lever was unfinished as you need to flip the lever up to retract the flaps. This is a simple cover to smooth out the bottom surface of the lever. It's a friction fit, so no permanent change, disassembly, glue, or fastener needed. Just print and press-fit in place. I printed in PLA and the friction was perfect: doesn't fall out and can be popped off with a fingernail or small screwdriver. If yours is too loose or tight, I'd try scaling the part by a tiny bit in your slicer. Or import the mesh into Fusion and futz with it there. Or you could pack the cavity on the original lever with blue-tack and hold it in that way.