honda goldwing speaker clip

thingiverse

This is a replacement speaker clip for early model Honda Goldwings. A coworker asked if I could make and print some, as the original clips are prone to breaking. The speaker cover itself is made of strong weather-resistant plastic, but the clips are not. I printed them out of PLA and ABS and made the clip part slightly larger to provide a better hold. You will need to sand down where the original clip was attached just a bit. Additionally, you will need to glue it down as well. To print these clips, place the model on its side with a brim/raft, and set the infill at 30% so that they have some flexibility. I found it helpful to print 8 at a time, just in case you need a few extras.