Honda Element SC Cup/Phone holder

thingiverse

UPDATE 12/10/19 --- My wife wasn't thrilled with the drink phone combo She thought it put the phone too close to the drink due to the angle of the phone holder slot So I redesigned it with an upright phone slot in a different orientation It's version 5 The glue-in bottom pieces remain unchanged I think I have to agree it will work better. ORIGINAL POST 12/09/19 --- My wife's 2007 Honda Element SC was purchased used and didn't come equipped with a cup holder So I printed the one designed by Jack Hydrazine but it didn't fit because the corners lacked the proper radius So I remixed it to make it work My wife drives alone most of the time so she only needs one cup holder She doesn't use her phone or talk on it while driving but she often charges it and needed a place to hold it so that it wouldn't fall on the floor So I drew this cup holder to hold one drink and one phone The drink holder is sized for a standard soft drink can with a coozy or a small Gatorade bottle. You can print the main part face down with or without support Printing with support will produce nicer locking tabs The bottoms of both the phone slot and the drink holder are designed to be printed separately so that the main part doesn't have a large and difficult-to-remove support structure This makes it print faster too The bottoms of the drink holder and phone slot should be installed using cyanoacrylate glue. If you're printing on glass clean it carefully and spray a fresh coat of hair spray just before printing the main component If your Z offset is set correctly to make a good first layer it will come off the build plate looking like a factory part.