Homework Robot Case

thingiverse

The Case for My Robot Homework Tracker. Make Your Own HW Bot: https://www.youtube.com/watch?v=6jryb6Zh6VU&index=1&list=PL06BiYWvHjWGk4CjczXqqsREpSnmVM35s My Robotics YouTube Channel: https://www.youtube.com/channel/UC30-LaHNkzaeGdlvy42rKyw Print Settings Rafts: I Turned It Off Supports: Don't Need To Worry About It Resolution: It's Fine, Just Use Standard Infill: Ten Percent Is A Good Number Notes: Every Piece Printed With Supports, Even Though Some Probably Didn't Need Them Post-Printing Now That The Pieces Are All Put Together, The Main Lid Needs To Be Glued Or Taped Down To Stay Closed. To Do This, You Will Need: Code: http://www.todayifoundout.com/wp-content/uploads/2015/09/homework_tracker_ino.zip Parts: LCD: https://www.sparkfun.com/products/709 Potentiometer: https://www.sparkfun.com/products/9806 Six Buttons Six One Thousand Ohm Resistors One Switch A Five Volt Regulator An Arduino Board A 28 Pin DIP Socket A Nine Volt Battery A 9V Connector A Circuit Board The Circuit Diagram Is Available At The End Of The Video