Homematic Table / Desk Stand Tischaufsteller

thingiverse

Table / desk / shelf stand for Homematic & Homematic IP thermostats. The first print even came out great as is, without leaning it or using supports. Currently trying printing it 15 degrees backwards and only with build plate support to make the upper overhang easier. See photos. The result of these tests shows that leaning works well with special breakaway or water soluble material but not well with the same material. For best quality print with 3 perimeters, 1mm top/bottom, seam on the backside right or left, 0.1mm layers, <= 40mm/s speed, <= 25mm/s for outer walls and top/bottom, 25% infill. In this quality it prints in 17 hours and needs 70g of material. Print the two clamps separately and glue them together with superglue or plastics glue. Make sure they are oriented correctly, the "fin" should point outwards (see zoom photo).