HOMEMADE HOG STRETCHER

thingiverse

If you need help, would like one made for you, or need help acquiring the 3D printed parts, feel free to contact /u/Meat_Sudden or '.j.o.j.' on Discord :) Print settings: Use 0.12mm layer height for the ruler/bearing piece so that the markings will be visible. Use arachne mode as well so that it will be the correct thickness. After printing, rapidly move this piece up and down the rod to wear down/remove any irregularities and ensure smooth motion. Here is a complete list of the parts you will need: mcmaster: 316 Stainless Steel Corrosion-Resistant Compression Springs x2 ($8.82 for 2) https://www.mcmaster.com/8969T811/ Passivated 18-8 Stainless Steel Pan Head Phillips Screws x2 ($6.68 for 10-pack) https://www.mcmaster.com/92000A526/ Tapered Heat-Set Inserts for Plastic x2 ($13.06 for 10-pack) https://www.mcmaster.com/94180A386/ amazon: Gas Spring End Fitting M6 Female Thread 8mm Hole ($11 for 2-pack) https://www.amazon.com/dp/B09B7G1QRY Threaded Heat-Set Inserts Brass for Printed Plastic Parts M6 ($11 for 20-pack) https://www.amazon.com/dp/B09ZNW4PC9 Fully Threaded Rod M6 x 300mm ($9.49 for 2-pack) https://www.amazon.com/dp/B0BLGML4MW M4 Hook Bolt 304 Stainless Steel Screw in Hooks ($7.59 for 10-pack) https://www.amazon.com/dp/B08CCZYL5T see the remix source for specific instructions on putting together. note that not all hardware parts from the original are necessary (e.g. the screw-in hook screws directly into the knob).