Homebrew Wifi/GPS Celestron enclosure

prusaprinters

<p><i><strong>An updated, more compact version is available here:</strong></i></p><p>https://www.prusaprinters.org/prints/67382-homebrew-wifibluetooth-gps-accessory-for-aux-bus-c</p><p>Original:</p><p>This is a case for a Wifi + GPS + ESP32 project used to connect to Celestron telescope mounts. The project can be found here:<br><a href="https://www.cloudynights.com/topic/743750-homebrew-wifibluetooth-accessory-for-aux-bus/">https://www.cloudynights.com/topic/743750-homebrew-wifibluetooth-accessory-for-aux-bus/</a> . Post 220 shows it wired up.<br>This was spawned from an earlier project that just used an Arduino to provide GPS data to the mount. The new project adds Wifi capability to mimic the dongle.<br>This particular design is suitable for a 1/2 length protoboard (Adafruit-style) that has central mounting holes, although it could be fairly easily modified for boards that have corner holes, I think. M3x8mm flat head screws were used to secure the protoboard.<br>The case is held together with M3x 20 or 25mm screws and nuts (25mm will sit a little proud in the sloped section). The exterior screws can be flat/button/socket style.</p><h3>Print instructions</h3><p>Print with the large flat faces down. Most printers <i>should</i> be able to handle the 45 degree slope on the front cover. No supports. You might need to clean out the screw holes a bit, again, depending on how well you have tuned things like overhangs and bridging.</p>