Holy Stone 700d battery and charger holder

thingiverse

Holy Stone 700d charger. It will probably work with the Holy Stone 700, but probably won't work with the 700E, but those are guesses based on looking at those batteries on Amazon. I have only tried it with my 700d batteries. You will have to press out the pin for the little flaps on the stock charger dongle, then pull the flaps, and put the pin back in. It should snap in perfectly and be snug. The batteries will slide in very snugly also. Not sure a swollen battery will go, but pretty sure you shouldn't be charging a swollen battery in anything but a bunker anyway. :). I used PLA, which worked beautifully. ABS might shrink, not sure if everything would fit, the tolerances are pretty tight. But you could just stretch the whole model a little if printing a material that shrinks too much. I printed with a full raft, and supports everywhere, it was around 110 grams of PLA and about 9 hours on my Ender Pro. This is the same as the previous version I posted, except that I had tried to print that one horizontally. The supports were a pain to get out, and the quality on the visible surfaces looked worse, so I put it back to a vertical print. Easier to clean up supports, and probably about the same wasted material. The holes don't even really need to be there, they are there on the off chance the battery gets hot charging, but with I doubt they do as they are fed off of a 7 watt to 15 watt charger, and most of those watts are charging the battery, not heating it.