Holy Family - "A Quiet Moment"

prusaprinters

A few years ago, someone had gifted me with this statue of the Holy Family. The gift statue was made from a solid block of stone. I wanted something that was smaller and lighter, so I was on a quest to make a 3D model of it. I technically didn't make it. I did some photogrammetry on it and it turned out quite well. Print Settings Printer Brand: Prusa Printer: I3 MK3S Rafts: Doesn't Matter Supports: Yes Resolution: .15 Infill: 15-20% it's up to you Filament: Sunlu PLA White or Marble Notes: This print will take forever to print, just keep an eye out on it at intervals... Post-Printing ============= Use a pair of pliers to break away the supports. Be very careful as to where you grab on to. You can then clean it up with a sharp knife. Again, be extra careful not to damage the print and especially yourself. Category: Sculptures