Holster for Commercial Electric OT-112R circuit tester

prusaprinters

<p>I inspect prefabricated equipment shelters designed to hold radio transmission equipment as a part of my job, and I use this circuit tester to confirm that all of the outlets are wired correctly.&nbsp;</p><p>My problem is that if the tester falls to the bottom of my leather tool pouch, everything else has to come out before I can retrieve the tester.</p><p>My solution is this little holster which can clip to the the tool pouch, the tool belt, or my regular belt.</p><p>The bottom floor has a NEMA 5-15 dummy plug that the tester friction fits into to keep it from just falling out of the holster.</p><p>This prints fine without supports but a brim is recommended to prevent corner lifting.&nbsp;</p><p>Most of these testers are about the same size so this may fit other models.</p><p>Link to the design on Tinkercad if you wish to tinker:</p><p><a href="https://www.tinkercad.com/things/fwPBFfkFKgb">https://www.tinkercad.com/things/fwPBFfkFKgb</a>&nbsp;</p>