Hologram Stand for Samsung S2 (version 2)

thingiverse

I think many of us have old cell phones at home that are worthless for sale; so, I just use my Samsung S2 as a lively decoration in my office. The hologram pyramid can be cut from an acrylic transparent sheet. You can make one using a plastic book binding cover; check out the link below by Harit Bandi: http://www.instructables.com/id/HOLOGRAM-a-glimpse-of-future/ Or, simply get this: http://hologrampyramid.net I have two sets of bolt lengths. Both work well, but shorter bolts are likely easier to drive into the hole if printed at a lower resolution. I've also added a top cover in this revision. While it's not necessary, it helps provide better viewing quality when placed directly below bright light. Print Settings: * Rafts: No * Supports: No * Resolution: 0.2mm * Infill: 15% Notes: The bolts should be printed with finer resolution (about 0.1mm) for best results. Post-Printing: The bolt holes are a bit tight. You can either use finer resolution (best at 0.1mm) or use a Dremel to clean up the holes. I find it's better to view the hologram with a dark sheet covering the top opening. I'll update the model with a top cover later.