hollow shaving bowl

thingiverse

made thing shaving bowl. it's hollow, so that you can fill the area between the outer layer and the inner layer with hot water, and have nice, hot lather for shaving. the outer and inner layers are pretty thin, 1.2mm, so it should be printed with enough "outer layers" to make that 100%. infill should be at least 15%, because there is some kind of a column holding between the bottom of the outer layer and the bottom of the inner layer, (the only hollow part) that needs at least 15% to be able to have a nice inner bottom (no sagging because of bridging). could be printed in PLA, but be careful how hot your water is or else your bowl might become soft and malleable. ABS would be perfect for pretty much any hot tap water. If you like it, like it. if you make it post a made it (REALLY), and comment on how good (or bad) it is... thanks! this was inspired by https://www.thingiverse.com/thing:1634087 PS: simplify3d has a hard time with this part, it closes up the spout. CURA pruduces it perfect. I'm not certain about other slicers. but don't use simplify3d, or at least not without inspecting the sliced part first.