holder for hair dryer (glueable+fast print)

thingiverse

Human: Definition: Wall-mounted holder designed to securely hold a hair dryer in place. For permanent attachment, apply adhesive directly to the back of the holder. List of Parts / Dimensions: 1x Holder: Measuring 10.5 x 10.5 x 3.2 cm, with a central hole 9.5 cm in diameter. Printing time: Approximately 6 hours and 30 minutes; material usage: 18 meters of PLA filament, weighing 51 grams. 1x Strip of double-sided tape or 2x Screws paired with 2 dowels for added stability. Scaling the design down is feasible without issue. Scaling up may impact structural integrity. Hints: To ensure a strong adhesive bond, prepare surfaces by cleaning them thoroughly with alcohol and allowing time to dry completely. Sanding the back side of the holder will also enhance connection stability. If properly executed, this assembly should withstand loads of approximately 1.5 kg permanently. For screw-in installation, choose suitable fasteners that complement your wall material (avoid adhesion on wallpaper). Opt for a moderate infill density to maintain structural integrity; excessive thinning can compromise the design's ability to support weight. Recommendations include: A wall thickness of 3 mm Top and bottom thicknesses of 1 mm Infill levels exceeding 33% Prioritize a thicker exterior shell over increased infill for maximum stability. Disclaimer: I disclaim all liability for damages resulting from product usage, installation, or manufacturing.